Removal And Installation - Dodge ram truck 3500 1996 Service Manual

8V - 6 OVERHEAD CONSOLE SYSTEMS BR
REMOVAL AND INSTALLATION (Continued)
(3) Pull the front of the console down slightly, then
move i t rearward until the mounting clips detach
from the roof panel (Fig. 4).
Fig. 4 Overhead Console Remove/Install
(4) Disconnect the wire harness connector from the
compass/thermometer/display module.
(5) Reverse the removal procedures to install.
COMPASS/THERMQSVIETER/DISPLAY MODULE
(1) Remove the overhead console as described in
this group.
(2) Remove the three screws securing the compass/
thermometer/display module to the overhead console
housing (Fig. 5).
J948C3
Fig. 5 Compass/Thermometer/Display Module
Remove/Install
. (3) Unplug the lighting harness connector from the
compass/thermometer/display module (Fig. 6).
Fig. 6 Lighting Harness Connector
(4) Remove the module from the overhead console
housing.
(5) Reverse the removal procedures to install.
TEMPERATURE SENSOR
(1) Disconnect and isolate the battery negative
cable.
(2) Locate the temperature sensor, on the radiator
support on the driver's side just behind the grille
(Fig. 7).
Fig. 7 Temperature Sensor
(3) Unplug the temperature sensor wiring connec­
tor.
(4) Remove the temperature sensor mounting bolt
and remove the sensor.
(5) Reverse the removal procedures to install.