Powertrain Control Module; Servo Cable; Speed Control Switch; Stop Lamp Switch - Dodge ram truck 3500 1996 Service Manual

B R — _
R E M O V A L A N D I N S T A L L A T I O N ( C o n t i n u e d )
VEHICLE SPEED CONTROL SYSTEM 8H - 11
Fig. 10 Servo Cable Hairpin Clip
(2) With throttle blocked to full open position,
align hole in cable sleeve with hole in servo pin and
install hairpin clip.
(3) Insert servo studs through holes in cable
sleeve.
(4) Install 2 attaching nuts and tighten to 6 N-m
(50 in. lbs.) torque.
(5) Connect vacuum hose to servo.
(6) Connect electrical connector to servo terminals.
(7) Install battery tray. Tighten all battery tray
mounting hardware to 16 N-m (140 in. lbs.) torque.
(8) Install battery in vehicle making sure battery
is properly positioned on battery tray.
(9) I f equipped, install battery heat shield.
(10) Install battery holddown clamp, making sure
it is properly positioned on battery. Tighten bolt to 4
N-m (35 in. lbs.) torque.
SPEED CONTROL SWITCH
WARNING: B E F O R E ATTEMPTING TO DIAGNOSE,
REMOVE OR INSTALL ANY AIRBAG SYSTEM OR
RELATED STEERING W H E E L AND STEERING COL­
UMN COMPONENTS YOU MUST FIRST DISCON­
NECT AND ISOLATE THE BATTERY NEGATIVE
(GROUND) C A B L E . WAIT 2 MINUTES FOR SYSTEM
CAPACITOR TO DISCHARGE B E F O R E FURTHER
SYSTEM S E R V I C E . FAILURE TO DO S O COULD
RESULT IN ACCIDENTAL DEPLOYMENT AND POS­
S I B L E PERSONAL INJURY.
REMOVAL
(1) Disconnect and isolate negative battery cable
from battery.
(2) From underside of steering wheel, remove 2
speed control switch mounting screws (Fig. 11).
CLOCKSPRING
SWITCH 908M-1
Fig. 11 Speed Control Switch Remove/Install
(3) Pull switch module assembly from wheel and
unplug electrical connector.
INSTALLATION
(1) Plug electrical connector into switch module.
(2) Install switch with 2 screws.
(3) Tighten screws to 1.5 N-m (15 in. lbs.) torque
STOP LAMP SWITCH
Refer to Group 5, Brakes for removal/installation
and adjustment procedures.
SERVO CABLE
REMOVAL/INSTALLATION
(1) Remove air cleaner (all except V-10 and diesel
engine).
(2) Using finger pressure only, remove speed con­
trol cable connector at bellcrank by pushing connec­
tor off the bellcrank (Fig. 12), (Fig. 13) or (Fig. 14).
DO NOT try to pull connector off perpendicular to
the bellcrank.
(3) Squeeze tabs on speed control cable and push
out of locking plate.
(4) Remove servo cable from servo as described in
Speed Control Servo Remove/Install.
(5) Reverse removal procedures to install.
POWERTRAIN CONTROL MODULE
For Removal/Installation refer to Group 14, Fuel
Injection System.