Before Working With The Machine; Product Description; Mode Of Operation; Special Equipment - Miele PG 8164 Operating Instructions Manual

Before working with the machine

3 Before working with the machine
 Have the machine set up by an authorised service technician or your dealer ( 15).
 Have the machine connected as per the locally applicable standards and the regulations of the authorised
mechanics (water, waste water, electrical system) ( 16 and 17).
 After connecting the water and the power properly, contact the relevant Miele Service Department or your
dealer for the commissioning of the machine and for providing training in its operation. Have yourself and
your operating personnel trained in the operation of the machine.
4

Product description

4.1 Mode of operation

The boiler and the tank fill and are warmed up to the operating temperature after the machine is switched on.
During the heating phase, the lighting of the start button (3) changes gradually from red to green. When the
target temperatures are reached, the machine is ready for use. The start button lights up green.
The machine is fully automatic with programmes consisting of three steps: Wash, Drain and Rinse. While a
wash programme is running, the start button gradually changes from blue to green.

4.2 Special equipment

The following special equipment is available:
 Internal water softener ( 6)

4.3 Display (Touchscreen) and start button

On the screen touch-sensitive buttons are displayed. Operate the screen with your fingers only, not with
sharp objects. Each touch of a button is confirmed by a beep. Events such as e.g. the end of the programme
or malfunctions are indicated by a sequence of tones.
INFO The authorised service technician can deactivate the beep and the sequence of tones.
Operational state
38
Activating the display
 Touch the display with your finger.
 The display turns on and then off again after a short time. This
saves energy and prevents accidental switching on of the
machine.
Switching on the machine, see chapter  7.2.
INFO
(a) On/Off button
(b) Self-cleaning programme
(c) Switch to info level 1  info level 2  PIN menu
(d) Start button