Pictogram
Meaning
Internal water
treatment is
exhausted
Integrated water
treatment
exhausted
Service interval is
running out
Need for descaling
Lower spray arm is
blocked
Upper spray arm is
blocked
The strainer is
blocked
Energy optimization
Malfunction with
error code
9.1 Accessing the error code
In the display, the following symbol flashes:
Tap the following buttons in turn:
1
is displayed only when the water back-flow counter has been programmed 12.7.
2
is displayed only when the machine is connected to an equipment with energy optimisation
Possible cause
Low salt
The water back-flow counter reads
0.
1
The number of operating hours /
washing cycles set in the controls
has been reached.
INFO: This function is not
activated in factory.
The number of operating hours set
in the control system has been
reached.
Spray arm is not correctly
engaged
Spray arm obstructed by, e.g. a
piece of cutlery
Spray arm blocked by soiling
Spray arm obstructed by, e.g. high
dishes
Spray arm blocked by soiling
Heavily soiled strainer
On-site energy optimisation
equipment switches individual
2
electrical consumers (heating
elements).
Various
The error codes are displayed in area (a).
INFO
Contact an authorised service technician for the repair.
Press the button (b) twice to leave the menu.
Remedy
Fill the salt reservoir with
regenerating salt ( 6.2).
12.7
Contact an authorised service
technician for the maintenance.
Starting the descaling programme
( 12.5.1).
Correctly engage the spray arm.
Remove the obstruction.
Clean the spray arm bearings
( 8.2).
Remove the obstruction.
Clean the spray arm bearings
( 8.2).
Remove, clean and replace the
strainer
Wait until the on-site energy
optimisation equipment switches
off.
Display the error code ( 9.1) and
assign the repair to an authorised
service technician.
Malfunctions already resolved are also displayed
here (e.g. ERR 1 OK).
Malfunctions
GB
49