Table of Contents
Advertisement
<Note>
1. When connecting to RS485 or RS422, you should connect the ground among devices.
If not, it may cause abnormal operation or damage on device.
6.3. Connecting & Setting sensor input
6.3.1. Specification
In order to run sensor input of WebEye 2.0 B101 normally, the following conditions are required.
Input Ch.
Input type
Spec.
Supported sensor
Connecting
Available input pulse range
Performance
Output current
6.3.2. Diagram of sensor input
6.3.3. Connecting
When connecting sensor 1, inset cables to 1, 2 pins (1+, 1-) as followings. Connect sensor 2~4 equally.
4Ch. Photo coupler differential inputs
NO / NC
Dry contact
Connecting the trimmed wire to terminal block
Min. 500ms
Typical DC 12mA
28
Advertisement
Table of Contents
