Setting Network; When Connected To Ethernet; When Connected To Xdsl - WebGate webeye 2.0 b101 Installation Manual

5.3. Setting Network

5.3.1. When connected to Ethernet

When WebEye 2.0 B101 is connected to Ethernet, set IP address and another information in "Network"
tab.
Setting IP address manually
(1) Enter IP address.
(2) Enter subnet mask.
(3) Enter gateway.
(4) Enter DNS.
(5) Enter the "Apply" button
Setting IP address automatically
(1) Check "DHCP Enable".
(2) Press the "Apply" button.
<Note>
1. If checking "DHCP Enable", WRS should be set.
2. When using cable modem or xDSL (automatic access modem), set it as "Ethernet" type.

5.3.2. When connected to xDSL

When WebEye 2.0 B101 is connected to xDSL line, set as follows then connect to xDSL line.
(1) Select "xDSL" type in "Network" tab.
(2) Enter ID and password for connecting to xDSL.
(3) Press the "Apply" button.
<Note>
1. xDSL has three kinds; ADSL, HDSL, and VDSL It can be used, when using PPPoE protocol.
2. When setting Network with xDSL, WRS menu should be set. (except using static IP)
3. If Network is set as xDSL type, Ethernet can't be connected.
4. User's ID and password is supplied from each xDSL ISP.
5. When using automatic connecting modem, even though Network line is xDSL type, a value should be
set as Ethernet.
18