Removing The Heater - Whirlpool WED99HEDW0 Technical Education

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Heater
1. Unplug dryer or disconnect power.
2. Remove drain hose from standpipe or laundry tub.
3. Perform the procedures on page 4-15, "Removing the
Rear Panel" prior to performing the following steps.
Heater
4. Disconnect the two heater terminals from the side of the
inlet duct.
Remove Heater
Terminals
n
4-16 HybridCare™ Dryer with Heat Pump Technology

Removing the Heater

High-Limit
Thermostat
Aux. Fan
Drain Port
Figure 1
Inlet Duct
Figure 2
5. Remove the 1/4" hex-head screw securing the heater
connector to the inlet duct (see Figure 3).
Heater
Connector
6. Remove the two (2) 1/4" hex-head screws securing the
heater assembly to the inlet duct (see Figure 4). Remove
heater assembly from dryer.
Remove heater
assembly screws
Figure 5 - Heater Assembly
Remove screw
Figure 3
Figure 4