Removing The Moisture Sensor - Whirlpool WED99HEDW0 Technical Education

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Moisture Sensor
1. Unplug dryer or disconnect power.
2. Perform the procedures on page 4-4, "Removing the Top
Panel" and "Removing the Console" prior to performing
the following steps.
3. Perform the procedures on page 4-7, "Removing the Front
Panel" prior to performing the following steps.
4. Disconnect Moisture Sensor connector (see Figure 1).
Moisture Sensor
Connector
n
4-8 HybridCare™ Dryer with Heat Pump Technology

Removing the Moisture Sensor

Figure 1
5. Remove two (2) 1/4" hex-head screws securing the Outlet
Grill & Housing Assembly to the front bulkhead (see
Figure 2).
6. Lift up the Outlet Grill & Housing Assembly from the
bulkhead (see Figure 2).
Outlet Grill &
Housing Assy
Remove 2 Hex
Head Screws
7. Separate the two halves of the Outlet Grill & Housing
Assembly to access and remove the moisture sensor (see
Figure 3).
Sensor Tabs
Moisture Sensor
M/F Connectors
Figure 2
Sensor Connector
Figure 3