Whirlpool WED99HEDW0 Technical Education page 59

Removing the Belt, Drum, and Rollers (continued)
10. Remove the five (5) 1/4" hex-head screws from the lint
duct as illustrated in Figure 6. Swivel the lint duct down
from the bulkhead and remove.
11. Remove the four (4) 1/4" hex-head screws securing the
front bulkhead to the side panels as illustrated in Figure 7.
Lift the bulkhead up off the side-panel tabs and remove.
Side Panel Tabs
Remove 4 screws
12. Reach under the drum, (raise it as far as it will go), and
push the idler pulley arm, on the back of the drive motor,
to the left to relieve the tension on the belt, then remove
the belt from the pulley. See Figure 8.
Swivel down and
remove lint duct.
Figure 6
Figure 7
13. Slide the belt off the front of the drum and remove belt.
14. Lift the drum and remove it from the dryer cabinet.
To Remove a Roller
1. Pry the sides of the triangular ring out of the groove in the
roller shaft with a small screwdriver (see Figure 9).
Triangular Ring
2. Slide the roller off the roller shaft (see Figure 10).
Roller Shaft
3. To remove the roller shaft, remove the 9/16" nut and
washer from the roller support, and remove the support
and remaining triangular ring. See Figure 11.
Nut & Washer
HybridCare™ Dryer with Heat Pump Technology
COMPONENT ACCESS
Remove Belt
From Pulley
Push
Figure 8
Figure 9
Figure 10
Roller Shaft & Ring
Figure 11
n
4-11