Installation Requirements - Whirlpool WED99HEDW0 Technical Education

INSTALLATION

Installation Requirements

TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Wire stripper
1/4" & 5/16" nut driver
Utility knife
Level
Tools needed:
Leveling legs (4)
Cable ties (3)
Parts package is located in dryer drum. Check that all parts are
included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
n A UL listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to the
I
dryer must end in ring terminals or spade terminals with
upturned ends.
n A UL listed strain relief.
Additional Accessories: (Not supplied with dryer)
I
Refer to your Use and Care Guide for information about
accessories available for your dryer.
n
3-2 HybridCare™ Dryer with Heat Pump Technology
#2 Phillips screwdriver
Channel locks
Adjustable wrench
Tape measure
Pliers
6' drain hose
Cable ties (2)
Location Requirements
Location Requirements
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
I
I
I
I
I
I
38 / " Min.
3
4
(984 mm)
39" Max.
(990 mm)
27"
(686 mm)