Installing The Charcoal Tray Lifting System - Smoke hollow PS9900 Assembly & Operation

Assembly
Step 18: Installing the Charcoal Tray
Step 18
Lifting System
Fig. 18 A
Locate: Charcoal Tray Lift System Lift Han-
dle, (2) Hinge Pins and (2) "R" Clips
Procedure: Refer to Figs. 18A and 18B and
Slide the Lift Handle through the adjusting
slot and through the hole of the inside
plate. Align the hole in the end of the Lift
Handle with the holes in the "U" shaped
bracket located at the back of the Cabinet.
Inside Cabinet
Join the Lift Handle and the "U" shaped
Bracket by inserting a Hinge pin as shown
in Fig. 18C.
Fig.18 B
Then insert an "R" Clip through the hole in
the Hinge Pin. Attach the Lift Handle to the
Lift System by inserting a Hinge Pin
through the "U" shaped Lift Arm and the
hole in the center of the Lift Handle as
shown in Fig. 18D.
Then insert an "R" clip through the hole in
Hole
the Hinge Pin. You should now be able to
adjust the Charcoal Tray Lifting System to
your desired height by moving the Lift Han-
dle to the left and then raising or lowering it.
Fig. 18 C
Fig. 18 D
19