Smoke hollow PS9900 Assembly & Operation page 24

Assembly
Step24:SearBurner Assembly (Continued)
Step 24 Continued.
Fig. 24 F
Refer to Fig. 24F – Place the Sear Burner
Gas Control Knob over the valve stem, mak-
ing certain to align the flat portion of the stem
with the flat potion in the Knob and push the
Control Knob onto the stem until it is firmly
seated.
Refer to Fig. 24G – Locate the Sear Burner
and lift up the igniter wire that you moved
over to here from the Control Panel. On the
bottom of the Burner you will see a pin con-
Fig . 24G 1
nection to the electrode. Push the igniter wire
onto the pin. Now carefully so you do not pull
the wire off, tilt the burner open tube end
down and slide through the opening in the
housing and ONTO and OVER the nozzle
end of the gas valve. Looking from the un-
derside of the housing, make certain that the
valve tip is INSIDE the burner tube as Fig.
24H.
Refer to Fig. 24I – Fasten the Burner to the
bracket at the back wall of the housing using
(2) ST4.0x10 screws
Fig. 24G 3
Fig . 24G 2
Fig. 24 H
Fig. 24 I
24