Related Manuals for Maktec MT960
Summary of Contents for Maktec MT960
- Page 1 INSTRUCTION MANUAL Angle Grinder MT960 009389 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
ENGLISH SPECIFICATIONS Model MT960 Wheel diameter 100 mm Spindle thread M10 x 1.5 Rated speed (n) / No load speed ( 12000 (min Overall length 266 mm Net weight 1.4 kg Safety class • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. -
Page 3: Specific Safety Rules
Use personal protective equipment. Always 22. Keep cutting tools sharp and clean. Properly wear eye protection. Protective equipment such maintained cutting tools with sharp cutting edges as dust mask, non-skid safety shoes, hard hat, or are less likely to bind and are easier to control. hearing protection used for appropriate conditions 23. - Page 4 The arbour size of wheels, flanges, backing 13. Do not run the power tool while carrying it at pads or any other accessory must properly fit your side. Accidental contact with the spinning the spindle of the power tool. Accessories with accessory could snag your clothing, pulling the arbour holes that do not match the mounting accessory into your body.
- Page 5 Safety Warnings Specific for Grinding and Abrasive e) Support panels or any oversized workpiece Cutting-Off Operations: to minimize the risk of wheel pinching and a) Use only wheel types that are recommended kickback. Large workpieces tend to sag under for your power tool and the specific guard their own weight.
-
Page 6: Functional Description
25. Always be sure that the tool is switched off Shaft lock and unplugged or that the battery cartridge is 1. Shaft lock removed before carrying out any work on the tool. 26. Observe the instructions of the manufacturer for correct mounting and use of wheels. Handle and store wheels with care. -
Page 7: Operation
To tighten the lock nut, press the shaft lock firmly so that CAUTION: the spindle cannot revolve, then use the lock nut wrench Always be sure that the side grip is installed • and securely tighten clockwise. securely before operation. To remove the wheel, follow the installation procedure in Screw the side grip securely on the position of the tool reverse. - Page 8 Makita Corporation Anjo, Aichi, Japan 884860-931...