Related Manuals for Maktec MT904
Summary of Contents for Maktec MT904
- Page 1 INSTRUCTION MANUAL Angle Grinder MT904 MT905 015065 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model MT904 MT905 Depressed center wheel diameter 125 mm 150 mm Max. wheel thickness 6 mm Spindle thread M14 or 5/8" (country specific) Rated speed (n) / No load speed (n 11,000 min 10,000 min Overall length... -
Page 3: Grinder Safety Warnings
Do not expose power tools to rain or wet Power tool use and care conditions. Water entering a power tool will 18. Do not force the power tool. Use the correct increase the risk of electric shock. power tool for your application. The correct Do not abuse the cord. - Page 4 Operations such as sanding, wire brushing, 10. Hold the power tool by insulated gripping polishing or cutting-off are not recommended to surfaces only, when performing an operation be performed with this power tool. Operations for where the cutting accessory may contact which the power tool was not designed may create a hidden wiring or its own cord.
- Page 5 c) Do not position your body in the area where 20. Make sure the wheel is not contacting the power tool will move if kickback occurs. workpiece before the switch is turned on. Kickback will propel the tool in direction opposite 21.
-
Page 6: Functional Description
To stop the tool from the locked position, pull the switch FUNCTIONAL DESCRIPTION trigger fully, and then release it. ASSEMBLY CAUTION: Always be sure that the tool is switched off and • unplugged before adjusting or checking function CAUTION: on the tool. Always be sure that the tool is switched off and •... -
Page 7: Maintenance
Installing or removing depressed center CAUTION: grinding wheel/Multi-disc Never switch on the tool when it is in contact with • the workpiece, it may cause an injury to operator. (optional accessory) Always wear safety goggles or a face shield during •... - Page 8 Replacing carbon brushes 1. Limit mark 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time.
- Page 12 Makita Corporation www.makita.com 885369-1...
Need help?
Do you have a question about the MT904 and is the answer not in the manual?
Questions and answers