Mitsubishi Electric apricot ft series Owner's Handbook Manual page 75

T r o u b l e s h o o t i n g
CD-ROM drive
If you have problems accessing a CD, check that you have allowed a
few seconds for the disk to spin up to full speed, that the disk is the
correct way up in the drive (printed side upwards) and that it is a
data CD. Remember that with a conventional CD-ROM drive you
cannot write to a CD.
Hard disk drives; IDE
If you encounter problems accessing an IDE hard disk drive, use the
BIOS Setup utility to check that the drive is correctly specified, and
that the drive's controller is enabled. Check also that the disk has
been correctly formatted, and that the permissions assigned by the
operating system allow the intended access.
Hard disk drives; SCSI
If you have just fitted a new SCSI drive, or device, check that you
have used a valid 'ID' that does not conflict with other SCSI drives
or devices is the system. Check also that the SCSI bus is correctly
terminated on only the last drive in the system. Look in any
documentation for information.
On boot up, just after POST, a list is displayed of the devices
attached to the SCSI interface, which shows the device, its
parameters and the set 'ID'.
OWNER'S HANDBOOK 8/5