Table of Contents
Advertisement
Adding more memory
Fitting and removing DIMMs
M o t h e r b o a r d F e a t u r e s & U p g r a d e s
You can give your PC more memory by adding or replacing
memory modules called "DIMMs".
The motherboard's two DIMM sockets accept DIMMs of up to
128 Mbytes in any combination (giving a maximum memory
capacity of 256 Mbytes).
IMPORTANT
The DIMMs you use must have the following specification: gold
contacts, 3.3V, 64-bit, unbuffered, either SDRAM-type with Serial
Presence Detect (SPD) and a CAS latency of 2 at 66 MHz or else
EDO-type with 60 ns timing. If you use any other type of DIMM you
risk damaging the motherboard.
Before you begin
1.
Turn off the computer and unplug all power cords.
2.
Take suitable anti-static precautions and remove the right-
hand side and top panels. For more information see the section
on "Anti-static precautions" in the Safety & Regulatory Notices
at the start of this manual.
3.
Remove any expansion cards that impede access to the DIMM
sockets.
4.
Lay the system unit on its side.
To install a DIMM
1.
Take the DIMM out of its anti-static packaging. Hold it by its
ends and avoid touching the metal contacts.
2.
Align the DIMM with the chosen socket, ensuring that the
socket end clips are not obstructing.
◊ The indents along the connector edge are asymmetrical to
prevent the DIMM being fitted into the socket the wrong
way round.
OWNERS HANDBOOK
5/7
Advertisement
Table of Contents
