Flashforge Creator Pro User Manual page 36
Hide thumbs
Also See for Creator Pro:
- User manual (55 pages) ,
- Quick start manual (40 pages) ,
- Start up and instruction manual (27 pages)
Table of Contents
Advertisement
NOTE: Do not check "the 'use raft/support' option. If you want to print dual colors with PLA
filament, then perform the following settings:
If you want to print dual colors with
ABS
filament, select
Replicator slicing defaults
under the
Slicing Profile
column, and lower the
Feedrate
to
60
and
Travel Feedrate
to 80.
Click the
Generate Gcode
option for both boxes. After the Gcode is generated, click on the
gcode
tab as highlighted below and change HBP temperature to
50
if you are printing with PLA and save
this modification by going to
File
> Save.
35
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Creator Pro and is the answer not in the manual?
Questions and answers