Feeding The Filament Using Replicator G Control Panel - Flashforge Creator Pro User Manual

see：
▶ Start Preheating
Right Extruder
Left Extruder
Platform
4) Press page up key
Heating:
R Extruder: 033/230C
L Extruder: 033/230C
Platform: 024
This means the left extruder is heating up, when it reaches 220°C. First
bit until you see filament come out of the
have withdrawn the filament inside the nozzle successfully.

6.4 Feeding the Filament Using Replicator G Control Panel

The following can only be performed while the printer is connected to the computer.
Open the Replicator G software, click the icon in the red box, this is the control panel icon. The
dialogue box shown below will then pop up.
To heat the right extruder and feed material, click the right extruder on the upper right corner of the
control panel and manually modify the temperature in the "Right Target" setting for the extruder
temperature control changing the temperature to 220°C. A red line will be plotted in the temperature
ON
ON
OFF
back to Start Preheat, and Press
nozzle,
OK key, you will see:
then pull it out
27
push in the filament
quickly. This will ensure you
a little