Topcom IP100 User Manual page 17

6.5.3 Net Service
HTTP Port:configure HTTP transfer port, default is 80.User may change this port to enhance
system's security. When this port is changed, please use
http://xxx.xxx.xxx.xxx:xxxx/ to reconnect.
Telnet Port:configure telnet transfer port, default is 23.
RTP Initial Port: RTP initial port.
RTP Port Quantity:Maximum RTP port quantity, default is 200
Notice:
Settings in this page won't take effect unless save and reboot the device.
If you need to change telnet port or HTTP port, please use the port greater than 1024,
because ports under 1024 is system remain ports.
HTTP service if HTTP is set to 0.
Topcom IP100
Topcom IP100
15