Network - Topcom IP100 User Manual

6.3

Network

6.3.1 Wan Config
WAN port network setting page.
Support static IP, dynamic obtain IP and PPPoE.
• Configure Static IP:
----Enable Static;
----Set IP100's IP address in the IP Address;
----Set netmask in the Netmask field;
----Set router IP address in the Gateway;
----DNS Domain:
----Set local DNS server in the Preferred DNS and the Alternate DNS
• Configure to dynamic obtain IP
----Enable DHCP;
If there is DHCP server in your local network, IP100 will automatically obtain WAN
port network information from your DHCP server.
• Configure PPPoE:
----Enable PPPoE
----PPPoE server: Enter "ANY" if no specified from your ITSP.
----Enter PPPoE username and pin in the username and password.
IP100 will automatically obtain WAN port network information from your ITSP if
PPPoE setting and the setup are correct.
Notice: If user accesses the IP phone through WAN port. He/She should use the new
IP address to access the IP phone when the WAN port address was changed.
Topcom IP100
Topcom IP100
9