AEG AR 4020 Instruction Manual page 67

Remove sleeve (D) and frame (B) from the unit. Use
‹
installation keys (C), if necessary.
Place the sleeve in the ISO slot.
‹
Bend the claws outward with a screwdriver for perfect
‹
fit.
Check the sleeve for tight fit.
‹
Connect the ISO female connectors of the unit with
‹
the two ISO male connectors of the vehicle.
Connect the antenna to the antenna connector at the
‹
rear of the unit.
Secure the unit against theft, if necessary. Attach bolt
‹
and mounting strip with the fastening materials at the
firewall.
Carefully slide the unit into the sleeve until it locks
‹
into place.
RESET (25) with a pen or other pointed object
Press
‹
after all connections are made.
Attach the front panel (A) as described under "Attach
‹
Front Panel".
CAUTION
Cable damage possible!
►
To avoid cable damage observe the cables when slid-
ing the unit into the sleeve.
Attach the frame.
‹
Remove Unit
Follow these instructions to remove the unit:
‹
Remove the frame.
‹
Insert left and right installation keys in the slots left
‹
and right (the claws are now bent back).
Slide the unit out of the sleeve.
‹
NOTE
►
Unevenness of the casing can cause the claws to
lock. Unlock the claws with the installation keys, if
necessary.
Toyota or Nissan Installation
NOTE
►
Sleeve, frame and mounting strip are not needed.
Use the threads on the side of the casing (A) to mount the
unit on the vehicle bracket (supplied with your car). The
holes are marked with T (for Toyota) and N (for Nissan).
A
D
B
C
Loosen the mounting screws for the hooks left and
‹
right at the front of the unit and remove the hooks.
Mount the brackets (B) with screws on the unit (D).
‹
Connect External Audio Device
Connect line out of the external audio device to
‹
IN (12) jack on the front panel.
Select playback mode for external device by repeatedly
‹
pressing MODE (22) until AUX is displayed.
ENGLISH
67
B
AUX