Table of Contents
Advertisement
Chapter 6: CONFIGURATION
This chapter describes the power-on sequence, logging-in, changing the default password, basic Avaya
Secure Router 3120 and user configuration, and factory default configuration.
Applying Power
Before applying power to a Secure Router 3120, make sure that the appropriate procedures
in
INSTALLATION
connected to the Secure Router 3120. To apply power to the Secure Router 3120:
1. Ensure that the Secure Router 3120 is connected to a power source.
2. Press the rocker switch on the Secure Router 3120 back panel to the on position (
The fans start, the LEDs cycle, and the Secure Router 3120 performs a self test. At the
successful conclusion of the self-test sequence, the Link Status LEDs turn red, and then green.
The Power LED illuminates green. Other status LEDs will be in various states. This is a normal
condition when the Secure Router 3120 is not configured for specific network line conditions.
Note:
If the Power LED does not illuminate green, see
Status
on page 101 for more information.
The login prompt is displayed on the console screen.
Logging In
If you have not established a local or remote console connection, see
page 38 for more information.
If you are connected to the Secure Router 3120 with a modem, verify that the modem is
configured correctly. See
configuration parameters.
Avaya Secure Router 3120 Installation Guide
on page 23 have been completed, and that an operator console has been
| ).
Remote Access
Table 49: LEDs: Secure Router 3120
on page 38 for information about modem
Operator Interface
on
December 2010
45
Advertisement
Table of Contents
