Table of Contents
Advertisement
TROUBLESHOOTING
<slot/port>
<t1>
Configuring loopback testing
Use the following procedure to configure loopback testing.
Procedure steps
1. To configure loopback testing, enter Test Mode.
2. Specify an interface and slot/port.
3. Configure loopback testing.
Table 19: Variable definitions
Variable
<interface>
[line_ct3]
[line_t1]
[payload_t1]
[remote]
<slot/port>
<t1>
<type>
Temperature Sensor Readings
The internal temperatures of the router can now displayed through CLI across all Secure
Router products. Below is a table of the temperature thresholds for each of the Secure Routers.
76
Avaya Secure Router 3120 Installation Guide
Variable
test
<interface> <slot/port>
loopback [line_ct3] [line_t1 <t1>] [payload_t1 <t1>] [remote
<line_ct3> <line_t1> <payload_t1> <type>]
Note:
If a test is issued on a link that is part of a bundle, the user will be given the option
to continue or abort.
The interface to test.
Configure a CT3 for loopback line testing.
Configure a T1 for loopback line testing.
Configure a T1 for loopback payload testing.
Configure interface for remote loopback testing.
The slot/port combination to use.
The T1 or range of T1s for testing.
The loopcode for testing. Available option is ansi_fdl.
Value
• 2^20
• QRSS
The slot/port combination to use.
The T1 or range of T1s for testing.
Value
December 2010
Advertisement
Table of Contents
