INSTALLATION
Refer to the following sections for additional modem configuration instructions.
USR Sportster
Dip Switches on USR modems
1. down (DTR Override)
2. up or down (either is OK)
3. up (Suppress result codes)
4. down (No echo)
5. up (Answer on the first ring)
6. down (DCD Override)
7. up (Load NVRAM [not factory])
8. up (Dumb Mode)
To configure the modem:
1. Set dip switch eight (8) down.
2. Cycle the modem's power switch to the ON position.
3. Connect to the modem via serial terminal software.
4. Send the following command string to the modem, (this will set the modem to factory
5. Set dip switch eight (8) up.
6. Cycle the modem power switch again.
MultiTech MT5656 ZDX (non-voice data/fax)
1. Send the following initilization string to the modem.
2. Cycle the modem power switch
42
Avaya Secure Router 3120 Installation Guide
• Turn hardware flow control off
default, set the connect rate to 9600bps, and finally save the configuration to
NVRAM):
AT &F &N6 &W
AT &F E0 S0=1 &D0 S37=9 &K4 $SB9600 %E0 Q1 &W Z
December 2010