Replacing The Gas Cylinder - SUNWIND 420128 Instruction Manual

TO TURN OFF THE HEATER
1. Press and turn the control knob to OFF position
2. Turn off the valve on the gas cylinder and disconnect the cylinder.
WARNING
Do not move the heater, or
cover it with protective
cover after it has
turned off until
temperature
has cooled down
1. Close the valve of the gas cylinder.
2. Disconnect the regulator from the cylinder following the instructions
that came with your regulator.
3. Replace the cylinder.
4. In the absence of any flame, remove the plug or seal cap from the
cylinder valve.
5. Check for the presence and good state of the gasket before
connecting the regulator.
6. Perform leak test using soapy water solution.
1. Changing of cylinder must be undertaken in a flame-free atmosphere.
2. Make sure that all taps on the consuming appliance are in closed
position.
Always close the valve of the gas cylinder after use or in case of a

disturbance.
Remove the pressure regulator and the hose attachment if the

heater is not to be used for a period of time.
Cylinder must be stored outdoors in a well-ventilated area out of the

reach of children.
Disconnected cylinder must have threaded valve plugs tightly

installed and must not be stored in garage or any other enclosed
area.
Storage of heater indoors is permissible only if the cylinder is

Variable control knob >
been
the
Igniter >

REPLACING THE GAS CYLINDER

WARNING
STORAGE
54