Gas Requirements; Leakage Test - SUNWIND 420128 Instruction Manual

Use butane, propane or LPG only.

The heater is designed for use with 11-13 kg (24-28 lbs.) cylinder.

Maximum size of cylinder suitable for
the appliance, w/regulator attached, is Ø31 cm x 64 cm (Ø12" x 25").
Inner dimension of stand within the supporting bars is Ø32 cm x 69
cm (Ø12.6" x 27").
The appliance requires approved gas hose in 60 cm length and a

regulator, or a gas hose in 140 cm length and a regulator if no gas
pipe (approx. 84 cm) is used.
Regulator maximum inlet pressure must not exceed 690 kPa (100

PSI).
Regulator outlet pressure to be 28 mbar (2.8 kPa or 11" W.C.) to 50

mbar depending to destination country.
The hose and regulator assembly must conform to local standard

codes.
The installation must conform to local codes, or in the absence of

local codes, to the standard for the storage and handling of liquid
petroleum gases.
A dented, rusted or damaged gas cylinder may be hazardous and

should be checked by your gas supplier. Never use a gas cylinder
with a damaged valve connection.
The gas cylinder must be arranged to provide for vapor withdrawal

from the operating cylinder.
Avoid twisting the flexible tubes and hoses.

Never connect an unregulated gas cylinder to the heater.

Disconnect the gas cylinder when the heater is not use.

Gas connections on the heater are leak tested at the factory prior to
shipment. A complete gas tightness check must be performed at the
installation site due to possible mishandling in shipment or excessive
pressure being applied to the heater. The heater must be checked with
a full cylinder.
5. Make sure the safety control valve is in the OFF position.
6. Make a soapy water solution of one part liquid detergent and one part
water. The soapy watersolution
can be applied with a spray bottle, brush or rag to all gas connections.
Soap bubbles will appear in case of a leak.
7. Turn the gas supply ON.

GAS REQUIREMENTS

LEAKAGE TEST

47