Cleaning And Care; Connecting Gas Line To Lpg Gas - SUNWIND 420135 Instruction Manual

adequate air ventilation.

CLEANING AND CARE

Wipe off exterior surfaces with soft, moist rag and soap water. Do not clean
-
heater with cleaners that are combustible or corrosive.
Remove debris, spider and insect nests from ventilation opening of the LPG
-
Gas Cylinder enclose, control compartment, burner and circulation air
passageways of the appliance with heavy-duty pipe cleaner or compressed
air to keep appliance clean and safe for use. Never clear ports or other
openings with toothpicks or other article that will break and block the
ports.
Do not paint the flame screen, control panel or reflector.
-
Cover the burner unit with the supplied protective cover when the heater is
-
not in use. Wait until the appliance is cool before covering.
In a salt-air environment, such as near an ocean, corrosion occurs more
-
quickly than normal. Check frequently for corroded areas and repair them
promptly.
-
Connecting gas line to LPG Gas Cylinder
CAUTION: The gas governor, flexible rubber pipe and clamps are not supplied
with this appliance and must be used proper ones, according to National Rules
in force.
The gas governor has to be set for 28-30/37/50 mbar.
Connect appliance pipe holder with proper flexible gas rubber pipe and fix it
using proper clamps. If some gasket is needed, it must be according to
Standard EN 549. If other material to guarantee tightness could be used,
they must be in line with Standard EN 751 only.
Check the gas tightness with soap water each time you connect the pipe
according to "Leakage Test".
10