Gas Requirements; Leakage Test - SUNWIND 420135 Instruction Manual

Never operate appliance in an explosive atmosphere like in areas
-
where gasoline or other flammable liquids or vapors are stored.
Warning: "Be carefully, accessibly parts may be very hot, Keep away
from young children" when you see "HOT" on the appliance.

GAS REQUIREMENTS

The gas governor, flexible gas rubber pipe and clamps, are not supplied
-
with this appliance; buy them
replace both taking into consideration expire date, warnings of this
Instruction Manual and National Rules in force.
Supply pressures to appliance:
-
Nominal inlet pressure is 28-30/37/50 mbar
Min inlet pressure: 20 mbar
Max inlet pressure is: 50 mbar
Gases to be supply: Butane, Propane or mixture of them
-
LPG Gas Cylinder size: 15 kg (maximum)
-
Use gas governor approved according to Standard EN 12864, according to
-
National Rules in force; make sure it is in good condition and substitute it
not over 10 years, as properly.
Check the flexible gas rubber pipe and other gas connections, at least once
-
per month and each time the LPG Gas Cylinder is changed. If it shows signs
of cracking, splitting or other deterioration, it shall be exchanged with a
new flexible gas rubber pipe according to National Rules in force of same
length (but not over 1,5 m) and of the equivalent quality.
The installation must be done according to National Rules in force.
-
A dented, rusted or damaged LPG Gas Cylinder, maybe hazardous and
-
should be checked by your LPG Gas Cylinder supplier. Never use a LPG Gas
Cylinder with a damaged valve connection.
The LPG Gas Cylinder must be arranged to provide for vapor withdrawal
-
from the operating cylinder.
Never connect a LPG Gas Cylinder without a gas governor, to the appliance.
-
Disconnect the LPG Gas Cylinder when the appliance is not use.
-
according to National Rules in force and

LEAKAGE TEST

7