Installation; Rear Door Outer Belt Weatherstrip; Removal; Rear Door Secondary Weatherstrip - Dodge Dakota Sport 2001 Service Manual

AN
REAR DOOR OUTER BELT
WEATHERSTRIP

REMOVAL

(1) Lower glass.
(2) Lift corner of weatherstrip upward and remove
weatherstrip from outer door panel.

INSTALLATION

(1) Position weatherstrip on outer door panel.
(2) Press into place.
(3) Raise glass.
REAR DOOR SECONDARY
WEATHERSTRIP
REMOVAL
(1) Separate the secondary seal from the inner
door panel (Fig. 9).
Fig. 9 Rear Door Secondary Seal
1 - REAR DOOR SILL SECONDARY SEAL
INSTALLATION
(1) Thoroughly clean the area of old adhesive. Use
Mopar Super Kleen or equivalent.
(2) Position the secondary seal on the inner door
panel.

REAR DOOR WEATHERSTRIP

REMOVAL
(1) Remove door sill trim.
(2) Loosen upper and lower B-pillar trim to access
weatherstrip.
(3) Remove C-pillar trim.
WEATHERSTRIP/SEALS
(4) Pull quarter panel trim outward to access
weatherstrip.
(5) Pull weatherstrip from pinch flange around
door opening.
INSTALLATION
(1) Clean pinch flange
(2) Position the weatherstrip on the pinch flange
around door opening and press into place.
(3) Install quarter panel trim.
(4) Install C-pillar trim.
(5) Install B-pillar trim.
(6) Install door sill trim. Ensure the clips attach-
ing the sill trim to the door sill are fully seated.
(7) Install A-pillar trim.
ROOF RAIL WEATHERSTRIP/
RETAINER
REMOVAL
(1) Release door latch and open door.
(2) The rearward corner of the weatherstip is
adhesively attached to the body. Peel back the corner
of the weatherstrip to release it from the body.
(3) Pull weatherstrip from retainer.
(4) Remove screws attaching retainer to roof rail
(Fig. 10).
(5) Separate retainer from vehicle.
Fig. 10 Roof Rail Weatherstrip/Retainer
1 - ROOF RAIL WEATHERSTRIP
2 - RETAINER
23 - 141