Installation; C-Pillar Trim; Removal; Carpets And Floor Mats - Dodge Dakota Sport 2001 Service Manual

AN
B-PILLAR TRIM (Continued)

INSTALLATION

(1) Position trim panel in vehicle.
(2) Route shoulder belt through access slots in
B-pillar trim panel.
(3) Connect speaker
equipped.
(4) Position B-pillar trim panel on B-pillar and
press to seat push-in fasteners.
(5) Install shoulder belt turning loop.
(6) Install door sill cover as necessary.

C-PILLAR TRIM

REMOVAL

(1) Remove the seat belt turning loop. (Refer to 8 -
ELECTRICAL/RESTRAINTS/SEAT
RETRACTOR - REMOVAL)
(2) Using a trim stick C-4755 or equivalent,
remove the upper c-pillar trim panel (Fig. 7).
(3) Remove the screws and remove position the
lower c-pillar aside.
(4) Remove the seat belt anchor and route seat
belt though the lower c-pillar trim panel.
(5) Remove the lower c-pillar trim.
Fig. 7 Upper C Pillar Trim
1 - UPPER C PILLAR TRAY
2 - LOWER C PILLAR TRIM SCREWS
INSTALLATION
(1) Place the lower c-pillar trim into the vehicle
and route the seat belt through the trim.
harness connector,
BELT
(2) Install the seat belt anchor. (Refer to 8 - ELEC-
TRICAL/RESTRAINTS/SEAT BELT & RETRACTOR
- INSTALLATION)
(3) Install the lower c-pillar trim and install the
screws.
if
(4) Install the upper c-pillar trim.
(5) Install the seat belt turning loop.

CARPETS AND FLOOR MATS

REMOVAL
(1) Remove seat.
(2) Remove door sill and cowl trim covers.
(3) Remove seat belt anchors.
(4) Remove floor
equipped.
&
(5) Remove rear stowage tray/storage box.
(6) Pull carpet out from under quarter panel trim
and cab back panel trim.
(7) Fold carpet or mat toward center of cab.
(8) Remove carpet or mat through door opening
(Fig. 8).
Fig. 8 Floor Carpet or Mat
1 - CARPET
2 - CAB
INSTALLATION
(1) Position the carpet in the cab and align all
holes.
(2) Slide carpet under quarter panel trim and cab
back panel trim.
(3) Install rear stowage tray/storage box.
(4) Install floor shift boot/floor console, if equipped.
(5) Install seat belt anchors.
(6) Install door sill and cowl trim covers.
(7) Install seat.
INTERIOR 23 - 113
shift boot/floor console, if