Quarter Window - Dodge Dakota Sport 2001 Service Manual

AN
BACKLITE (Continued)
Fig. 1 Backlite
1 - URETHANE
2 - TAB
3 - BACKLITE
INSTALLATION—SLIDING BACKLITE
Review Safety Precautions and Warnings para-
graph at the front of this section before removing
glass.
(1) Trim urethane adhesive from around rear glass
opening fence leaving 1–2 mm of urethane on fence.
(2) Apply RIM primer 25 mm (1 in.) wide to the
mating surface of the backlite encapsulation.
(3) Apply Gurit-Essex
in.) wide to the mating surface of the backlite encap-
sulation.
(4) Apply blackout primer 25 mm (1 in.) wide to
the mating surface of the backlite encapsulation.
(5) Apply pinchweld primer 25 mm (1 in.) wide to
the backlite opening fence.
(6) Apply a 10 mm (0.4 in.) bead of urethane
around perimeter of backlite along the inside of the
encapsulation.
(7) Position backlite into backlite opening using
alignment pins in lower corners.
(8) Firmly push glass against rear window glass
opening fence.
(9) Bend tabs around edges of backlite opening
fence to retain glass.
(10) Clean excess urethane from exterior with
Mopar, Super Clean or equivalent.
(11) Install interior trim.
Betawipe 4000 25 mm (1
STATIONARY GLASS
BACKLITE VENT GLASS
REMOVAL
(1) Open vent glass to full open position.
(2) Slide the upper run channel out of the window
frame.
(3) Slide the vent glass upward to remove from the
window frame.
INSTALLATION
(1) Slide the vent glass downward into window
frame.
(2) Position the upper run channel into the win-
dow frame and slide it into place.
(3) Verify vent glass operation.

QUARTER WINDOW

REMOVAL
(1) Remove quarter trim panel.
(2) Remove the bolts attaching the latch to the cab
side panel (Fig. 2).
(3) Remove the nuts attaching the frame/hinge to
the B-pillar (Fig. 3).
(4) Remove the glass from the cab.
(5) If necessary, remove the latch from the glass.
Fig. 2 Quarter
1 - CAB
2 - QUARTER GLASS
23 - 133