Set Length; Show Logout - Enterasys b5 Manual

Example
This example shows how to set the terminal columns to 50:
B5(su)->set width 50

set length

Use this command to set the number of lines the CLI will display. This command is persistent
(written to NV‐RAM).
Syntax
set length screenlength
Parameters
screenlength
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the terminal length to 50:
B5(su)->set length 50

show logout

Use this command to display the time (in seconds) an idle console or Telnet CLI session will
remain connected before timing out.
Syntax
show logout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Sets the number of lines in the CLI display. Valid values are 0, which
disables the scrolling screen feature described in "Displaying Scrolling
Screens" on page 1‐9, and from 5 to 512.
set length
Enterasys B5 CLI Reference 3-29