Table of Contents
Advertisement
Defaults
None.
Example
This example shows how to set the RIP receive version to 2 for update packets received on the
VLAN 1 interface:
B5(su)->router(Config)#interface vlan 1
B5(su)->router(Config-if(Vlan 1))#ip rip receive version 2
ip rip authentication-key
Use this command to enable or disable a RIP authentication key (password) for use on an
interface. The no form of this command prevents RIP from using authentication.
Syntax
ip rip authentication-key name
no ip rip authentication-key
Parameters
name
Defaults
None.
Mode
Interface configuration: B5(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the RIP authentication key chain to "password" on the VLAN 1
interface:
B5(su)->router(Config)#interface vlan 1
B5(su)->router(Config-if(Vlan 1))#ip rip authentication-key password
ip rip message-digest-key
Use this command to enable or disable a RIP MD5 authentication key (password) for use on an
interface. The no form of this command prevents RIP from using authentication.
Syntax
ip rip message-digest-key keyid md5 key
no ip rip message-digest-key keyid
Specifies the password to enable or disable for RIP authentication.
ip rip authentication-key
Enterasys B5 CLI Reference 20-9
Advertisement
Table of Contents
