Table of Contents
Advertisement
Parameters
acl‐name
Defaults
If a specific ACL is not specified, information about all configured ARP ACLs is displayed.
Mode
Switch command, read‐write.
Example
This example displays information about the ARP ACL named staticARP.
B5(su)->show arpinspection access-list staticARP
ARP access list
permit ip host 192.168.1.10 mac host 00:01:22:33:44:55
permit ip host 192.168.1.20 mac host 00:0A:11:22:33:66
show arpinspection ports
Use this command to display the ARP configuration of one or more ports.
Syntax
show arpinspection ports [port-string]
Parameters
port‐string
Defaults
If a port‐string is not specified, information about all DAI‐enabled untrusted ports is displayed.
Mode
Switch command, read‐write.
Example
This example displays the ARP configuration of lag.0.1.
B5(su)->show arpinspection ports lag.0.1
Interface
----------
lag.0.1
(Optional) Specifies the ARP ACL to display.
staticARP
(Optional) Specifies the port or ports for which to display ARP
configuration information.
Trust State
Rate Limit
-------------
-------------
No
Burst Interval
(pps)
(seconds)
---------------
15
show arpinspection ports
1
Enterasys B5 CLI Reference 17-25
Advertisement
Table of Contents
