Clear Lldp Port Tx-Tlv - Enterasys b5 Manual

Table of Contents

Advertisement

clear lldp port tx-tlv

voice
voice‐signaling
guest‐voice
guest‐voice‐signaling
softphone‐voice
video‐conferencing
streaming‐video
video‐signaling
state 
tag 
vid 
cos 
dscp 
port‐string
Defaults
At least one application (or all) and one policy parameter must be specified.
Mode
Switch command, read‐write.
Example
This example returns all network policy values for all applications on port ge.1.1 to their default 
values.
B5(rw)->clear lldp port network-policy all state tag vid cos dscp ge.1.1
clear lldp port tx-tlv
Use this command to clear the optional LLDP and LLDP‐MED TLVs to be transmitted in 
LLDPDUs by the specified port or ports to the default value of disabled.
Syntax
clear lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmt-
addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [med-
cap] [med-pol] [med-loc] [med-poe]} port-string
6-34 Discovery Protocol Configuration
Applies command to the voice application.
 Applies command to the voice signaling application. 
Applies command to the guest voice application. 
Applies command to the guest voice signaling application. 
Applies command to the softphone voice application.
Applies command to the video conferencing application.
Applies command to the streaming video application.
Applies command to the video signaling application. 
(Optional) Clears the state of advertising the application 
information being configured to disabled.
(Optional) Clears the tag value of the application being configured 
to untagged.
(Optional) Clears the VLAN identifier for the port to the default 
value of 1.
(Optional) Clears the Layer 2 priority to be used for the application 
being configured to the default value of 0. (A value of 0 represents 
use of the default priority as defined in IEEE 802.1D.)
(Optional) Clears the DSCP value to be used to provide Diffserv 
node behavior for the application being configured to the default 
value of 0. (A value of 0 represents use of the default DSCP value 
as defined in RFC 2475.)
Specifies the port or range of ports to be affected.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the b5 and is the answer not in the manual?

Table of Contents

Save PDF