Examples
This example shows what is displayed when no VLANs are specified.
B5(su)->show arpinspection statistics
VLAN
----
5
This example shows what information is displayed when one or more VLANs are specified.
B5(su)->show arpinspection statistics vlan 5
VLAN
---- ---------- ---------- ---------- ---------- ---------- ---------- ---------
5
clear arpinspection validate
Use this command to remove additional optional ARP validation parameters that were previously
configured.
Syntax
clear arpinspection validate {[src-mac] [dst-mac] [ip]}
Parameters
src‐mac
dst‐mac
ip
Defaults
All parameters are optional, but at least one parameter must be specified.
Mode
Switch command, read‐write.
Usage
This command removes previously configured additional validation of ARP packets by DAI,
beyond the basic validation that the ARP packet's sender MAC address and sender IP address
match an entry in the DHCP snooping bindings database.
Use the show arpinspection vlan command to display the current status of the additional
validation rules.
Example
This example removes all 3 additional validation conditions.
B5(su)->clear arpinspection validate src-mac dst-mac ip
Forwarded
Dropped
------------
---------
0
DHCP
ACL
Drops
Drops
0
0
Clear, or remove, the verification that the sender MAC address equals
the source MAC address in the Ethernet header.
Clear, or remove, the verification that the target MAC address equals
the destination MAC address in the Ethernet header.
Clear, or remove, checking the IP address and dropping ARP packets
with an invalid address.
0
DHCP
ACL
Permits
Permits
0
0
clear arpinspection validate
Bad Src
Bad Dest
MAC
MAC
0
0
Enterasys B5 CLI Reference 17-27
Invalid
IP
0