Set Lldp Port Trap; Set Lldp Port Med-Trap - Enterasys b5 Manual

set lldp port trap

port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables both transmitting LLDPDUs and receiving and processing LLDPDUs from
remote systems on ports ge.1.1 through ge.1.6.
B5(rw)->set lldp port status both ge.1.1-6
set lldp port trap
Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
Syntax
set lldp port trap {enable | disable} port-string
Parameters
enable
disable
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables transmitting LLDP traps on ports ge.1.1 through ge.1.6.
B5(rw)->set lldp port trap enable ge.1.1-6

set lldp port med-trap

Use this command to enable or disable sending an LLDP‐MED notification when a change in the
topology has been sensed on the port (that is, a remote endpoint device has been attached or
removed from the port).
Syntax
set lldp port med-trap {enable | disable} port-string
6-26 Discovery Protocol Configuration
Specifies the port or range of ports to be affected.
Enable transmitting LLDP traps on the specified ports.
Disable transmitting LLDP traps on the specified ports.
Specifies the port or range of ports to be affected.