Configuring Arp Mad - HP 5130 EI series Configuration Manual

Step
3. Create a VLAN dedicated to
BFD MAD.
4. Return to system view.
5. Enter interface view or
interface range view.
6. Assign the port or the range
of ports to the BFD MAD
VLAN.
7. Return to system view.
8. Enter VLAN interface view.
9. Enable BFD MAD.
10. Configure a MAD IP address
for a member device on the
VLAN interface.

Configuring ARP MAD

When you use ARP MAD, follow these guidelines:
Do not configure ARP MAD on VLAN-interface 1.
•
• Do not use the VLAN configured for ARP MAD for any other purpose.
If an intermediate device is used, you can use common data links as ARP MAD links. If no
•
intermediate device is used, set up dedicated ARP MAD links between IRF member devices.
• If an intermediate device is used, make sure the following requirements are met:
Run the spanning tree feature between the IRF fabric and the intermediate device.
Enable the IRF fabric to change its bridge MAC address as soon as the address owner leaves.
Create an ARP MAD VLAN and assign the ports on the ARP MAD links to the VLAN.
Command
vlan vlan-id
quit
•
Enter interface range view:
interface range { interface-type
interface-number [ to
interface-type interface-number ] }
&<1-5>
•
Enter interface view:
interface interface-type
interface-number
•
Assign the port to the VLAN as an
access port:
port access vlan vlan-id
•
Assign the port to the VLAN as a
trunk port:
port trunk permit vlan vlan-id
•
Assign the port to the VLAN as a
hybrid port:
port hybrid vlan vlan-id { tagged |
untagged }
quit
interface vlan-interface
vlan-interface-id
mad bfd enable
mad ip address ip-address { mask |
mask-length } member member-id
29
Remarks
The default VLAN on the device
is VLAN 1.
N/A
To assign a range of ports to the
BFD MAD VLAN, enter interface
range view.
To assign one port to the BFD
MAD VLAN, enter Ethernet
interface view.
The link type of BFD MAD ports
can be access, trunk, or hybrid.
The default link type of a port is
access.
N/A
N/A
By default, BFD MAD is
disabled.
By default, no MAD IP address is
configured on any VLAN
interface.
Repeat this step to assign a MAD
IP address to each member
device on the VLAN interface.