HP 5130 EI series Configuration Manual page 52

Figure 17 Network diagram
GE1/0/1~GE1/0/4
GE1/0/2
Device A
XGE1/0/25
XGE1/0/26
(IRF-port1/1)
XGE3/0/25
XGE3/0/26
(IRF-port3/2)
Device C
Configuration procedure
1. Configure Device A:
# Shut down the physical interfaces used for IRF connection. This example uses the SFP+ port
group that contains Ten-GigabitEthernet 1/0/25 to Ten-GigabitEthernet 1/0/28 for IRF
connection.
<Sysname> system-view
[Sysname] interface range ten-gigabitethernet 1/0/25 to ten-gigabitethernet 1/0/28
[Sysname-if-range] shutdown
[Sysname-if-range] quit
# Bind Ten-GigabitEthernet 1/0/25 and Ten-GigabitEthernet 1/0/26 to IRF-port 1/1.
[Sysname] irf-port 1/1
[Sysname-irf-port1/1] port group interface ten-gigabitethernet 1/0/25
[Sysname-irf-port1/1] port group interface ten-gigabitethernet 1/0/26
[Sysname-irf-port1/1] quit
# Bind Ten-GigabitEthernet 1/0/27 and Ten-GigabitEthernet 1/0/28 to IRF-port 1/2.
[Sysname] irf-port 1/2
[Sysname-irf-port1/2] port group interface ten-gigabitethernet 1/0/27
[Sysname-irf-port1/2] port group interface ten-gigabitethernet 1/0/28
[Sysname-irf-port1/2] quit
# Bring up the SFP+ ports and save the configuration.
[Sysname] interface range ten-gigabitethernet 1/0/25 to ten-gigabitethernet 1/0/28
[Sysname-if-range] undo shutdown
[Sysname-if-range] quit
Device E
IRF
XGE1/0/27 XGE2/0/27
XGE1/0/28 XGE2/0/28
(IRF-port1/2) (IRF-port2/1)
GE3/0/2 GE4/0/1
XGE3/0/27 XGE4/0/27
XGE3/0/28 XGE4/0/28
(IRF-port3/1) (IRF-port4/2)
IP network
GE2/0/1
Device B
XGE2/0/25
XGE2/0/26
(IRF-port2/2)
XGE4/0/25
XGE4/0/26
(IRF-port4/1)
Device D
48