HP 5130 EI series Configuration Manual page 53

[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
2. Configure Device B:
# Change the member ID of Device B to 2 and reboot the device to validate the change.
<Sysname> system-view
[Sysname] irf member 1 renumber 2
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
[Sysname] quit
<Sysname> reboot
# Connect Device B to Device A as shown in
the SFP+ group that contains Ten-GigabitEthernet 2/0/25 to Ten-GigabitEthernet 2/0/28 for IRF
connection.
# Shut down the physical interfaces.
<Sysname> system-view
[Sysname] interface range ten-gigabitethernet 2/0/25 to ten-gigabitethernet 2/0/28
[Sysname-if-range] shutdown
[Sysname-if-range] quit
# Bind Ten-GigabitEthernet 2/0/27 and Ten-GigabitEthernet 2/0/28 to IRF-port 2/1.
[Sysname] irf-port 2/1
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/0/27
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/0/28
[Sysname-irf-port2/1] quit
# Bind Ten-GigabitEthernet 2/0/25 and Ten-GigabitEthernet 2/0/26 to IRF-port 2/2.
[Sysname] irf-port 2/2
[Sysname-irf-port2/2] port group interface ten-gigabitethernet 2/0/25
[Sysname-irf-port2/2] port group interface ten-gigabitethernet 2/0/26
[Sysname-irf-port2/2] quit
# Bring up the SFP+ ports and save the configuration.
[Sysname] interface range ten-gigabitethernet 2/0/25 to ten-gigabitethernet 2/0/28
[Sysname-if-range] undo shutdown
[Sysname-if-range] quit
[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
The two devices perform master election, and the one that has lost the election reboots to form an
IRF fabric with the master.
3. Configure Device C:
# Change the member ID of Device C to 3 and reboot the device to validate the change.
<Sysname> system-view
[Sysname] irf member 1 renumber 3
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
[Sysname] quit
<Sysname> reboot
Figure 17, and log in to Device B. This example uses
49