Masonry Retainer Kit Option - Regency FP90 Owners & Installation Manual

Masonry Retainer Kit Option

For a non-self supporting veneer finish only.
1) Framing and plywood cannot extend past
the side and top stand-off spacers. Allow
for the thickness of the Non-Combustible
Material when framing so that the front of the
Fireplace and the Non-Combustible Material
are flush.
2) Unscrew the top stand-off and move the
ceramic blanket forward so it will be tight
against the mesh to make a seal.
2" (51mm) x 4" (102mm)
Diagram 1
3) Mesh must be positioned one way only to
allow the mortar to hold and not slide off.
Place "Middle" mesh (A) on the front and
position top grill edge frame. Check dimen-
sions from opening and mark and drill screw
holes. Depending on the installation, heavier
reinforcing wire screen may be required to
bridge the stand-off spacer area around the
perimeter of the unit. Hold in position with 2
screws while the door arch is centered.
Metal
Filler
Strips
.
LEFT
SIDE
UP
B
.
Non-Combustible Material
Do not restrict air flow through
the top and bottom louvers of
the fireplace. This will cause
overheating and possible ignition
of surrounding materials. Top
louver maybe closed only if
gravity feed kit option is used.
4) Place side metal filler strips in between stove
and framing to cover the stand-off space.
Fit the strips behind "A" so that they cover
the stand-offs, and will prevent mortar from
falling through the mesh.
5) Center door arch edge, mark and drill holes.
Note the top of the side pieces meet up with
the edges of the center arch. Attach arch
edge and bottom of grill edge to unit. The
door arch floats at each end so that it can
be adjusted to match the curve of the door.
TOP
UP
C
. .
. .
MIDDLE
UP
.
installation
Metal
Filler
. .
Strips
A
. .
.
RIGHT
SIDE
UP
B
.
FP90 Wood Fireplace |
|
23
23