Table of Contents
Advertisement
FIGURE 11
PRESS-STACK
CABLE
(67475)
5
STEP 11
• Route the new PRESS-STACK CABLE (5) around the pulleys and l-brackets as shown in STEP 11. (Remove pulleys for ease of
installation.)
PRESS-
STACK
CABLE
(67475)
5
FIGURE 12
STEP 12
• To assemble the PRESS-STACK CABLE (5)
follow the cable routing as shown and use the
following steps:
• Route the thread end of PRESS-STACK CABLE (5)
• Screw the threaded end of the PRESS-STACK CABLE
• SECURELY tighten the pulley connection from the
9
up and over the PULLEY in the TOP BOOM above
the WEIGHT STACK. (Remove pulley for ease of
installation.)
(5) approximately 1" into the end of the SELECTOR
SHAFT of the HEAD PLATE on the WEIGHT
STACK as shown in FIGURE 12.
previous step.
PRESS-STACK
CABLE
5
(67475)
Advertisement
Table of Contents
