ParaBody 445104 Assembly Instructions Manual page 7

STEP 8
• Remove two 2" PULLEYS (5) to the rear bracket on the TOP BOOM using one 3/8" THREADED SHAFT (9), two 3/8" WASHERS,
two 3/8" HEX NUTS (8), and two 3/8" LOCK NUTS (7) as shown in FIGURE 8.
• Discard the two 3/8 X 1/2" SPACERS.
ELASTIC
CORD
STEP 9
• SECURELY assemble the two previously removed 2" PULLEYS, one previously removed 3/8" THREADED SHAFT, one previously
removed 3-1/2" PULLEY, two previously removed 3/8" WASHERS, two previously removed 3/8" HEX NUTS, and two previously
removed 3/8" LOCK NUTS to the rear bracket on the TOP BOOM as shown in FIGURE 9.
• Position the elastic cords over the 2" PULLEYS as shown in FIGURE 9.
3/8 X 1/2" SPACER
3/8" THREADED ROD
3-1/2" PULLEY
3/8" THREADED ROD
3/8" WASHER
3/8" HEX NUT
2" PULLEY
3/8" LOCK NUT
TOP BOOM
3/8" HEX NUT
3/8" WASHER
2" PULLEY
3/8" LOCK NUT
7
FIGURE 8
TOP BOOM
FIGURE 9