Pressing Load - Kurzweil Forte Manual

Before you press the LOAD selection button in StorageMode, make sure you have plugged
the USB device containing your User Programs and/or Multis into the back of the Forte.
If your User Programs/Multis are located on your computer or Tablet, then use the cable that
plugs into the computer/Tablet USB port on the rear panel of the Forte.
If your User Programs/Multis are located on a USB flash drive, plug them into the Device
USB port on the rear panel of the Forte.

Pressing LOAD

Press the LOAD button when you have the hardware containing your User Programs/Multis
plugged into the USB port.
If no USB connection is detected by Forte, you will see the error message "Error: No valid
device inserted.".
Use the cursor buttons, -/+ buttons or the Alpha Wheel to browse the files in the currently
selected storage device.
NOTE : If the Forte is currently connected to your computer as
a MIDI controller, Saving or Loading a fi le in the PC Virtual Drive
will temporarily disconnect the Forte USB MIDI connection for
approximately 1 second. After Saving or Loading, the Forte may
need to be reselected as a MIDI device in your computer program.
Loading or Saving to the Flash Drive will not disconnect the USB MIDI
connection.
Storage Mode
The LOAD Page
13-7