Split And Layer Parameters; Zone Status; Program; Volume - Kurzweil Forte Manual

Multi Mode
The Split and Layer Soft Buttons

Split and Layer Parameters

Zone Status

Selecting Split or Layer makes a new Zone active. You can continue to add Zones to the
Multi by activating additional Zones with the Stat parameter or the front panel Zone
buttons. The Forte will display a message if you have already reached the maximum number
of active Zones (see About Zones on page 10-6 for more information on Zones).

Program

The Program parameter for the first available Zone determines the Program for the left-hand
side of the Split, also known as the "Split Program". This parameter is selected by default
when performing the Split function, and the default Split Program (245 Finger Bass) will be
selected. Choose a Split Program using the Category buttons, the Alpha Wheel, the Previous/
Next buttons, or enable the Keypad button and type an ID number followed by the Enter
button.

Volume

To change the volume of a Zone, use the cursor buttons to select the Volume parameter for
one of the Zones. To set a volume, use the Alpha Wheel, the Previous/Next buttons, or use
the keypad function of the Category buttons to type a volume (0-127) followed by the Enter
button.

Key Range

You can adjust the boundary between the left and right hand Programs on the keyboard by
adjusting the Key Range low and Key Range high parameters for each Zone. The keyboard
display for each Zone shows a visual indication of the Key Range by dimming keys that are
outside of the Key Range.
To change the Key Range of a Zone, use the cursor buttons to select the Key Range low or
Key Range high parameters for one of the Zones. Key Range low and Key Range high are
the left and right parameters, respectively, below the Key Range label. With one of these
parameters selected, set the Key Range by using the Alpha Wheel, the Previous/Next buttons,
or use the keypad function of the Category buttons to type a key number (0-127) followed
by the Enter button. With Key Range low or Key Range high selected, the value can also be
changed by holding the Enter button, then pressing the desired key.

Pan

To change the panning of a Zone (left/right stereo placement), use the cursor buttons to
select the Pan parameter for one of the Zones. To set a Pan value, use the Alpha Wheel, the
Previous/Next buttons, or use the keypad function of the Category buttons to type a pan
value (0-127) followed by the Enter button. A value of 0 is full left, 64 is center, and 127 is
full right. Other values will move the stereo placement in between these positions. A value
10-11