wsm m9540 Workshop Manual page 35

M9540Low Profile, WSM
Fuel Filling Port and Harness Cover
1. Unscrew the fuel filling port (1) fixing screw.
2. Remove the harness cover (2) both L.H. and R.H. side.
(1) Fuel Filling Port
Fender and ROPS Under
1. Remove the both fenders (1).
2. Remove the screw (3) for both side then take out the ROPS
under L.H. (4) and R.H. (2).
(When reassembling)
• Be sure to assemble the fender to the original height.
• If the adjusting shim (5) uses between the ROPS under and rear
axle case, assemble the shim to the original position.
• Be sure to check the ROPS slides smoothly, after assembling. If
ROPS does not slide smoothly, adjust with shim (5).
(1) Fender L.H.
(2) ROPS Under R.H.
(3) Screw
L3-S8
TRANSMISSION
(2) Harness Cover
W1013126
(4) ROPS Under L.H.
(5) Shim
(6) Rear Axle Case
W1013188
KiSC issued 09, 2008 A