Loading A Dvd-Ram Cartridge Vertically; Opening The Tray Manually - LG GSA-4167B Installation And Using Manual

Loading a DVD-RAM Cartridge Vertically

Note: The DVD-RAM drive must be in the horizontal position if you are using an 8cm
To load a DVD-RAM cartridge into a vertically mounted drive, do the following:
1. Press the Load/Unload button to open the tray. The tray slides out of the drive.
2. Insert the DVD-RAM cartridge so that the label-side of the shutter is facing up.
3. Push the DVD-RAM cartridge about 2cm toward the DVD-RAM drive.
4. Press gently on the shutter label so that the DVD-RAM cartridge sits firmly on the
tray.
5. To close the tray, press the Load/Unload button, or gently push the tray in.
Note: Do not extend the two upper retaining tabs when you operate the drive in the

Opening the Tray Manually

The tray should automatically open when you press the Load/Unload button. If it does
not automatically open, follow these steps to force it open manually:
1. Shut down and turn off the power to your system unit.
2. Insert the straightened end of a paper clip into the emergency eject hole until you
feel some resistance. See "Front View of DVD-RAM Drive" on page 1 if you are not
sure where the emergency eject hole is located.
3. Continue to push in the paper clip while you pull out the tray with your fingernail.
4. Pull the tray completely open and remove the disc. It is normal for the tray to make
a clicking sound while you are pulling it open.
disc.
vertical position.
Chapter 5. Using the 4.7GB SCSI-2 DVD-RAM Drive
19