LG GSA-4167B Installation And Using Manual page 16

Attention: Be sure to read "Handling the 4.7GB SCSI-2 DVD-RAM Drive" on page vii
1. Remove the drive from its bag.
2. Place the drive on top of the bag on a flat surface.
3. Refer to the figure on page 7. Locate pin positions 2, 3, and 4 on the drive. They
are the first three positions on the left side of the jumper block as you view the drive
from the back. The SCSI address is factory-set to 4.
4. Using Table 2 below as your guide, install jumpers in the correct positions to set the
SCSI address you previously chose.
Table 2. SCSI Address Settings
SCSI Address
5. Make sure the jumper on position 1 is set to Off. This position does not enable or
disable any function, and can be used as a spare jumper.
6. The jumper in position 5 should be set to Off. This position does not enable or
disable any function, and can be used as a spare jumper.
7. Make sure the jumper in position 6 is set to Off. This disables the drive's internal
terminator power. Terminator power is provided by the system through the SCSI
cable.
8. The jumper in position 7 should be set to Off. This position does not enable or
disable any function, and can be used as a spare jumper.
You can remove spare jumpers and store them in a safe place or install them in the Off
position on any unused pin position.
6
4.7GB SCSI-2 DVD-RAM Drive Installation and Using Guide
before you begin.
Position 2
0 Off
1 On
2 Off
3 On
4 Off
5 On
6 Off
Position 3 Position 4
Off
Off
On
On
Off
Off
On
Off
Off
Off
Off
On
On
On