Mitsubishi AJ65SBT-62DA User Manual page 56

5 PROGRAMMING
*Initial settings
*Changing of initial settings
Initial setting change
ƒ C ƒ j ƒ V ƒ ƒ ƒ ‹ Ý ' è • Ï X
*Processing at initial settings
*Setting of digital values
Digital value
ƒ f ƒ B ƒ W ƒ ^ ƒ ‹
setting
' l Ý ' è
*Analog output enable/disable specification
Analog output
ƒ A ƒ i ƒ ƒ O
enable
o — Í ‹ – ‰ Â
*Processing at error occurrence
Error reset
ƒ G ƒ ‰ [ ƒ Š ƒ Z ƒ b ƒ g
*Write of remote output signals
* The program enclosed by the dotted line is necessary only when the initial settings
are changed.
5 - 14
MELSEC-A
Analog output enable/disable
setting (RWw2)
Writes to master station
Output range/HOLD/CLEAR
setting (RWw3)
Writes to master station
Turns on initial data
processing completion flag
(RY18)
Turns on initial data setting
request flag (RY19)
Analog output enable/
disable setting (RWw2)
Writes to master station
Output range/HOLD/CLEAR
setting (RWw3)
Writes to master station
Turns on initial data setting
request flag (RY19)
Turns off initial data
processing completion flag
(RY18)
Turns off initial data setting
request flag (RY19)
CH.1 digital value setting
(RWw0): 500
CH.2 digital value setting
(RWw1): 1000
Writes to master station
Turns on CH.1 analog output
enable/disable flag (RY00)
Turns on CH.2 analog output
enable/disable flag (RY01)
Read CH. check code
(RWr0,RWr1)
Read error code (RWr2)
Turns on error reset request
flag (RY1A)
Turns off error reset request
flag (RY1A)
Y400 to Y41F are written into
RY00 to RY1F