Function - Mitsubishi AJ65SBT-62DA User Manual

3 SPECIFICATION

3.4 Function

Item
D/A output
enable/disable function
D/A conversion
enable/disable function
Output range changing
function
Function to specify hold
or clear of the analog
output when the PLC
CPU is in the STOP
status (HOLD/CLEAR
setting)
Offset/gain setting
Table 3.3 lists the functions of the AJ65SBT-62DA.
Table 3.3 AJ65SBT-62DA Function List
Specify whether the D/A conversion value is output or the offset value is output per
channel.
Note that the conversion speed is constant independently of the output
enable/disable setting.
Specify whether D/A conversion is enabled or disabled per channel.
The sampling cycle can be shortened by setting the unused channel to D/A
conversion disable.
You can set the analog output range per channel to change the I/O conversion
characteristics.
Select the output range setting from among the following 8 types.
Output Range
-10 to +10V
0 to 5V
1 to 5V
0 to 20mA
4 to 20mA
User range setting 1 (-10 to +10V)
User range setting 2 (0 to 5V)
User range setting 3 (0 to 20mA)
Specify per channel whether to hold or clear (output the offset value) the analog
value which is being output from each channel when the PLC CPU has entered the
STOP status or the AJ65SBT-62DA has stopped D/A conversion due to error
occurrence.
You can make offset/gain setting per channel without potentiometers to change the
I/O conversion characteristics freely.
Description
Set Value
0
H
1
H
2
H
3
H
4
H
5
H
6
H
7
H
3 - 8
MELSEC-A
Refer to
Section 3.5.2
Section 3.6.3
Section 3.6.4
Section 3.6.4
Section 4.4